Home Our services Parts and accessories Location / Contact Shop hours Customer charter Our facility Alarm Systems Tune Ups Oil changes Brakes Driveline Repairs Suspension Engine rebuilds Transmission Rebuilds Electrical Repairs Fuel Injection Service Carburator Rebuilds Make Runs Tire Repair & Installation Performance Modifications Crash Repairs Pickup Service


   
News:
 

Motorcycle Tune Ups

Pannon Moto Sports offers the most complete motorcycle tune up service around. Every full service tune up covers goes over a complete list of your manufactures recommended maintenance and a little more.

While most other shops and dealerships charge you for the bare bones minimum (oil, plugs, air filter, valve check). Pannon Moto Sports goes the extra mile and covers every inch of your motorcycle to ensure it is going to be trouble free for your safety and enjoyment. When we say full service, we mean FULL service.

Below is a list of work performed during a tune up:

Level 1:
- Change oil
- Replace oil filter
- Replace or service air filter
- Replace spark plugs
- Check and adjust ignition timing (if applicable)
- Clean or replace points (if applicable)
- Replace coolant if needed (if applicable)
- Synchronize carburetors or throttle bodies (if applicable)
- Set idle mixture (if applicable)
- Set idle speed
- Adjust timing belt tension (if applicable)
- Adjust any fuel injection sensors (if applicable)
- Replace fuel filter
- Lubricate all cables
- Adjust clutch
- Adjust throttle cables. Make sure throttle snaps back closed
- Adjust brakes (if applicable)
- Clean drive chain (if applicable)
- Adjust primary drive (if applicable)
- Lubricate and adjust drive chain/belt (if applicable)
- Change shaft drive oil (if applicable)
- Set tire pressures
- Inspect all lighting and safety equipment
- Lube all locks and pivot points
- Check lighting. Replace burned out bulbs as needed (extra cost for difficult to remove bulbs)
- Check brake pads
- Check wheel bearings
- Check swing arm pivot. Grease if applicable
- Check tire condition
- Check side stand safety and starter safety switches
- Check front forks
- Check and adjust steering head bearings. Grease if applicable.
- Road test

Level 2
- Flush brake fluid and bleed system (extra cost on certain ABS systems and BMW integral systems)

Level 3
- Check and adjust valves clearances